How to Ride the Motorcycle
105
Warning
If the optimized cornering ABS is not
functioning, the ABS warning light will
illuminate and a warning message is
shown in the display.
In this situation, the ABS will continue
to operate but without the optimized
cornering function, provided that:
- There are no other ABS faults
- The ABS has not been disabled by
the rider.
Do not continue to ride for longer than
is necessary with the warning light
illuminated. In the event of a fault,
contact an authorized Triumph dealer
as soon as possible to have the fault
checked and rectified.
In this situation, braking too hard
during cornering may result in loss of
motorcycle control and an accident.
ABS Warning Light
When the ignition switch is
turned to the ON position, it is
normal for the ABS warning
light to flash on and off.
If the ABS warning light is constantly
illuminated it indicates that the ABS
function is not available because the
ABS has a malfunction that requires
investigation.
If the ABS warning light becomes
illuminated while riding, it indicates that
the ABS has a malfunction that requires
investigation. A warning message may
be shown in the display.
Warning
The ABS warning light will illuminate
after three minutes, if the rear wheel
is driven while the motorcycle is on a
stand.
If the motorcycle was ridden prior to
being placed on a stand, this time will
reduced to one minute and the ABS
warning light will be accompanied by
the MIL.
This reaction is normal.
When the ignition is switched off
and the motorcycle is restarted, the
warning light(s) will remain illuminated
until the motorcycle reaches a speed
exceeding 6 mph (10 km/h).
To Next Page
Loading...
Need help?
General
