Maintenance
138
• Fill the reservoir between the MIN
level line and the MAX level line
using new DOT 4 brake fluid from a
sealed container.
•
Reinstall the float.
• Reinstall the diaphragm seal making
sure that it is correctly positioned
between the reservoir cap and
reservoir body.
•
Reinstall the reservoir cap.
• Reinstall the reservoir cap screws
and tighten to 18 lbf in (2 Nm).
Brake Light
Warning
Riding the motorcycle with defective
brake lights is illegal and dangerous.
An accident causing injury to the rider
and other road users may result from
use of a motorcycle with defective
brake lights.
The brake light is activated
independently by either the front or
rear brake. If, with the ignition ON,
the brake light does not work when
the front brake lever is pulled or the
rear brake pedal is pressed, have your
authorized Triumph dealer investigate
and rectify the fault.
Steering
Caution
To prevent risk of injury from
the motorcycle falling during the
inspection, make sure that the
motorcycle is stabilized and secured
on a suitable support.
Do not exert extreme force against
each wheel or rock each wheel
vigorously as this may cause the
motorcycle to become unstable
and cause injury by falling from its
support.
Make sure that the position of the
support block will not cause damage to
the motorcycle.
Steering Inspection
Warning
Riding the motorcycle with incorrectly
adjusted or defective steering head
bearings is dangerous and may cause
loss of motorcycle control and an
accident.
To Next Page
Loading...
Need help?
General
