Maintenance
157
Bulb Turn Signal Lights
2
1. Indicator lens
2. Screw
To replace the turn signal light bulb:
•
The lens on each signal light is held
in place by a screw located in the
body of the light.
•
Loosen the signal lens screw.
• Remove the lens to gain access to
the bulb for replacement.
•
Replace the bulb.
• Re-install the lens making sure that
the locating tang is correctly aligned
to the signal body.
•
Tighten the signal lens screw to
9 lbf in (1 Nm).
License Plate Light
The license plate light unit is a sealed,
maintenance free LED unit.
Tail Light
The tail light unit is a sealed,
maintenance free LED unit.
To Next Page
Loading...
Need help?
General
