Maintenance And Adjustment
133
Street Cup, Thruxton, Thruxton R
and Bonneville T120
1. Wire retainer
2. Headlight bulb
While supporting the light unit,
disconnect the multipin electrical
connector from the headlight bulb.
Remove the rubber dust cover.
Unhook the headlight bulb's wire
retainer.
The headlight bulb can now be removed.
Installation is the reversal of removal.
The position bulb is situated within the
headlight assembly and is a sealed,
maintenance‑free LED unit.
Daytime Running Lights (if fitted)
The Daytime Running Lights (DRL) are
situated within the headlight assembly
and are sealed, maintenance free LED
units. If DRL are fitted then there is no
position bulb.
Headlight Adjustment
Note:
• Always make sure the handlebars
are in the straight ahead position
when checking and adjusting the
headlight beam setting.
1. Headlight assembly mounting bolt
Vertical adjustment of the headlight
beam is controlled by loosening the
headlight assembly mounting bolts and
altering the position of the headlight
assembly.
Retighten the fixings after adjustment
to 10 Nm.
To Next Page
Loading...
Need help?
General
