Triumph Thruxton User Manual

General Information
45
System Display
Warning
Do not attempt to switch between
front and rear tyre display modes with
the motorcycle in motion as this may
lead to loss of motorcycle control and
an accident.
10
20
1
10
1
20
1
20
0
0
20
40
60
1
80
200
1
2
3
4
1. TPMS warning light
2. TPMS symbol
3. Tyre pressure
4. Front and rear tyre indicators
To view the tyre pressure display:
Make sure the motorcycle is stationary
and in neutral. Turn the ignition to the
ON position.
Press and release the SCROLL button
until PSI or bAr is shown in the display
screen.
Press and hold the SCROLL button for
one second to change between PSI and
bar.
Once PSI or bar has been selected, press
and release the SCROLL button to select
the front or rear tyre pressure.
When the tyre pressure monitoring
system has been selected, —— PSI or
bAr is shown in display screen until the
motorcycle is travelling at a speed
greater than 12 mph (20 km/h) and the
tyre pressure signal is received.
To exit the tyre pressure display, press
and release the SCROLL button until the
desired display screen is shown.
Sensor Batteries
When the battery voltage in a pressure
sensor is low, LO bAt will be displayed
and the TPMS symbol will indicate which
wheel sensor has the low battery
voltage. If the batteries are completely
flat, only dashes will be visible in the
display screen, the red TPMS warning
light will be on and the TPMS symbol will
flash continuously. Contact your
authorised Triumph dealer to have the
sensor replaced and the new serial
number recorded in the spaces provided
on page 44.
With the ignition switch turned to the
ON position, if the TPMS symbol flashes
for 10 seconds and then remains on
there is a fault with the TPMS system.
Contact your authorised Triumph dealer
to have the fault rectified.

Triumph Thruxton Specifications

General

Brand	Triumph
Model	Thruxton
Category	Motorcycle
Language	English