General Information
30
Hazard Warning Lights Button
To turn the hazard warning lights on
or off, press and release the hazard
warning light button.
The ignition must be switched on for the
hazard warnings lights to be activated,
but the hazard lights will remain active
if the ignition is switched off until the
hazard warning light button is pressed
again.
Left Handlebar Switches
The switches are illuminated
on Tiger 900 GT Pro and
Tiger 900 Rally Pro.
ckdf
5
6
1
2
3
7
8
9
10
4
1. Cruise control adjust switch (if equipped)
2. Daytime Running Lights (DRL) switch (if
equipped)
3. MODE button
4. Turn signal switch
5. Joystick button
6. Horn button
7. Heated grips switch (if equipped)
8. Front fog lights switch (if equipped)
9. High beam button
10. Rider heated seat switch (if equipped)
The following sections describe the
handlebar buttons and switches
functions.
Cruise Control Adjust Switch
The cruise control adjust switch is a two
way switch with the top marked RES/+
and the bottom marked SET/-.
For more information on cruise control
operation, see page 70.
Daytime Running Lights (DRL)
Switch (if equipped)
When the ignition is switched
ON and the daytime running
lights switch is set to DRL
mode, the daytime running
lights warning light will illuminate.
The daytime running lights and low
beam headlights are operated manually
using the DRL switch. Press the top
of the switch for DRL mode, and the
bottom of the switch for low beam
headlight mode.
Warning
Do not ride for longer than necessary
in poor ambient light conditions with
the Daytime Running Lights (DRL) in
use.
Riding with the daytime running lights
when dark, in tunnels or where poor
ambient light is apparent may reduce
the riders vision or blind other road
users.
Blinding other road users or reduced
vision in low ambient light levels may
result in loss of motorcycle control and
an accident.
To Next Page
Loading...
Need help?
General
