General Information
86
• Remove the seat from the
motorcycle.
3
1
2
1. Electrical connector
2. Clip
3. Heated passenger seat
Passenger Seat Installation
2
2
1
1
3
1. Passenger seat brackets
2. Locating feature
3. Rider's seat mountings
To install the passenger seat:
• Reconnect the heated seat’s
electrical connector (if equipped).
• Push down firmly on the rear of the
rider seat and hold.
• Engage the seat's two brackets into
the locating feature.
• Press down at the rear to engage in
the seat lock.
Rider's Seat
Warning
The rider's seat is only correctly
retained and supported once the
passenger seat is correctly installed.
Never ride the motorcycle with the
passenger seat detached or removed,
as the rider's seat will not be secure
and may move.
A loose or detached seat could cause
loss of motorcycle control and an
accident.
Rider's Seat Removal
1
1. Rider's seat
To remove the rider's seat:
• Remove the passenger seat (see
page 85).
• Grasp the rider's seat on either side,
and slide it rearwards and upwards.
• If equipped with heated seats,
disconnect the heated seat’s
electrical connector for complete
removal from the motorcycle.
To Next Page
Loading...
Need help?
General
