General Information
52
• The currently active riding mode
icon is shown in the right hand side
of the display.
To change the selected riding mode:
• Press the joystick left or right, or
repeatedly press the MODE button
until the required riding mode is
highlighted in the center of the
riding mode information tray.
• A brief press of the joystick center
will select the required riding mode,
and the riding mode icon in the right
hand side of the display will change.
• The selected mode is activated
once the following conditions for
switching modes have been met:
Motorcycle Stationary–Engine Off
• The ignition is switched ON.
• The engine stop switch is in the
RUN position.
Motorcycle Stationary–Engine Running
• Neutral gear is selected or the
clutch is pulled in.
Motorcycle in Motion
Within 30 seconds of selecting a riding
mode the rider must carry out the
following simultaneously:
• Close the throttle.
• Make sure that the brakes are not
engaged (allow the motorcycle to
coast).
Note
It is not possible to select OFF-ROAD,
OFF-ROAD PRO or RIDER modes while
the motorcycle is in motion, if the TC
settings are set to OFF-ROAD, OFF-
ROAD PRO or OFF in either of those
modes.
In this case, the motorcycle must be
brought to a stop before the riding mode
change can take place.
If a riding mode change is not
completed, the riding mode icon will
alternate between the previous riding
mode and the newly selected riding
mode until the change is complete or it
is canceled.
The riding mode selection is now
complete and normal riding can be
resumed.
Main Menu
To access the Main menu:
• The motorcycle must be stationary
with the ignition switched on.
• Press the HOME button on the right
handlebar switch housing.
• Scroll the Main menu by pushing the
joystick down/up until the required
option is selected and then press
the joystick center to confirm.
Main Menu Screen
To Next Page
Loading...
Need help?
General
