General Information
76
Traction Control Settings
Warning
If the traction control is disabled, the
motorcycle will handle as normal but
without traction control.
In this situation accelerating too hard
on wet/slippery road surfaces may
cause the rear wheel to slip which may
result in loss of motorcycle control and
an accident.
The traction control system can be
disabled as described in Bike Setup
on page 57, or set to the conditions
described in Riding Mode Configuration
on page 53.
Tire Pressure Monitoring
System (TPMS) (if equipped)
Warning
The daily check of tire pressures
must not be excluded because of
the installation of the Tire Pressure
Monitoring System (TPMS).
Check the tire pressure when the
tires are cold using an accurate tire
pressure gage, see the Tire section for
more information.
Use of the TPMS system to set
inflation pressures may lead to
incorrect tire pressures leading to loss
of motorcycle control and an accident.
Function
Tire pressure sensors are mounted
to the front and rear wheels. These
sensors measure the air pressure inside
the tire and transmit pressure data to
the instruments. These sensors will not
transmit the data until the motorcycle
is traveling at a speed greater than
12 mph (20 km/h). Two dashes will be
shown in the display area until the tire
pressure signal is received.
An adhesive label will be mounted to the
wheel rim to indicate the position of the
tire pressure sensor, which is near the
valve.
To Next Page
Loading...
Need help?
General
