- 28 -
3.6 Loading Media in Peel-off Mode (Option)
1. Lift the handle to open the printer
right side cover and refer to the
[Loading the Media] section to load
the media.
2. Using the front display panel to
calibrate the media. ( )
3. Enter the [Menu] to set peeler mode.
([Setting][Print Mode] [Peeler
Mode])
Note:
- Please calibrate the gap/black mark
sensor before loading media in
peel-off mode to avoid paper jam.
- Please calibrate the gap/black mark
sensor when changing media.
4. Open print head release lever to pull approximately 650mm of label through the front of the
printer and remove some labels.
5. Open the peeler off cover. Feed the liner between peel-off roller and platen roller.
6. Wrap the label onto the internal rewind spindle and wind the spindle counter-clockwise about 3~5
circles until the liner is properly stretched.
7. Close the peeler off cover and the print head mechanism.
8. Peeling will automatically start. Press the FEED button to test.
Loading path for peeler mode:
To Next Page
Loading...
Need help?
General
