Tyco Electronics Galaxy SC Controller J85501F-1
4 - 46 Configuration Issue 13 February 2001
other than the default 52.08V (48V) or 26.04 (24V) for which the default
alarm threshold levels have been chosen, or if Boost or Battery Thermal
Protection options are being utilized, these default threshold levels will
require modification.
Configure → Change Passwords
Galaxy SC has three levels of software security for the normal user
interface mode, plus a fourth password (default: LINEAGE) for the TL1
interface. The three normal user levels, their factory default passwords,
and their privileges are:
• User (default password: LINEAGE):
Read privileges for all settings and values in the system
Turn rectifiers on but not off Enable alarm cutoff
• Super-User (default password: SUPER-USER):
All privileges of a USER
Change any setting in the system except passwords
• Administrator (default password: ADMINISTRATOR):
All privileges of a SUPER-USER
Change the passwords in the system
Galaxy SC is not case-sensitive. Passwords and commands may be
entered in upper or lower case.
When initially setting up the site configuration in the path Options →
Set Up Sites, the Galaxy SC passwords and the login level are
configured. Since you must be at the Administrator level in order to
change passwords, the path Reports → Who Is Logged In can be used
to determine your present security level at any time. If the Galaxy SC
passwords are changed, remember to also change them under the
Options → Set Up Sites path for your next login attempt.
The “Passwords at Default” warning will not retire until all four
default passwords have been changed or the alarm report default is
changed to a “Record Only” alarm as previously shown in the
Configure → Alarms → Standard example. Many customers will
want to leave the USER (read-only) password at LINEAGE to allow
universal read access to the controller, but Tyco Electronics strongly
suggests that both the SUPER-USER and the ADMINISTRATOR
passwords be changed by the customer after initial configuration is
complete.
To Next Page
Need help?
General
