(3) Oil specification
Gear oil SAE 90W
(API GL-4 grade or higher)
REPLACING TRANSMISSION
FLUID FILTER CARTRIDGE
①
The HST oil lter is located under
the oor.
② Remove the hydraulic oil filter
element by turning it counterclock-
wise with a wrench.
③ Apply a thin lm of oil to the O-ring
of a new cartridge and install the
new cartridge by tightening it with
a hand. When its packing touches
the sealing surface, turn it approx.
2/3 turns further with a wrench.
④
Add hydraulic oil to the specied level.
⑤
Check the oil level with the dipstick
again. If still insufcient, add more.
►
If oil gets on your skin, it can ir-
ritate the skin and cause a skin
condition. Make sure to clean
your skin with soap and water
or hand cleaner thoroughly.
Make sure to cool down the
engine sufciently before drain-
ing oil. Oil is very hot and can
cause a burn if changing oil
right after the engine is stopped.
•
•
CAUTION
HST filter
5. REPLACING FILTER AND CARTRIDGE
TRANSMISSION STRAINER
CLEANING
①
When changing transmission
uid, clean with diesel fuel.
②
Unscrew the filter body support
bolt from the right lower section
of the rear transmission case
and gently pull the lter with pli-
ers to remove it.
►
T19O509A T19O510B