Ubee UBC1329AA00 Advanced Wi-Fi 6 Voice Gateway User Manual • February 2021 19
Example primary SSIDs with cable modem MAC address
64:7C:34:FE:0D:17:
• 2.4GHz: WIFIFE0D17
• 5GHz: WIFIFE0D17-5G
• NOTES: You can change the SSID(s) to a personalized network
name. For detailed information and parameters refer to Wi-Fi Edit
2.4GHz on page 40 and Wi-Fi Edit 5GHz on page 45. If you change
the SSID, the device does not revert to the default value when the
device is power cycled, but does revert to this default value if the
device is reset to factory defaults
4. When prompted, enter the network key, also called the pre-shared key
(PSK) or the wireless password. This is a key for each device, and thew
default is the same for both the 2.4 and 5GHz radios (both the primary
and guest wireless networks). The default key is a randomly generated
string, 16 characters in length.
• Example PSK: K1XXSX9YTSLIDN23
• NOTE: You can change the pre-shared key/wireless password to a
personalized one for each wireless network. For detailed information
and re-naming parameters refer to: Wi-Fi Edit 2.4GHz on page 40
and Wi-Fi Edit 5GHz on page 45.
5. If using WPS, enter the WPS personal identification number (PIN). The
WPS PIN is a randomly-generated number and is used to connect wireless
clients via the Wireless Protected Setup (WPS) method. It can be found on
the WLAN WPS screen. Refer to Wi-Fi Add Wi-Fi Client on page 49.
6. Confirm connectivity by opening a Web browser on the wireless client
device, and going to any Web site.
NOTE: The Web interface allows you to customize the configurations and
capabilities for the device. For a full explanation of all Web interface
functions, refer to Using the Web User Interface on page 21.
7. If you have wireless issues or questions, refer to Deploying &
Troubleshooting the Wireless Network on page 93.
2.3 Troubleshooting the Installation
Use the following tips to troubleshoot the installation.
1. None of the LEDs are on when I power on the UBC1329AA00.
To Next Page
Loading...
Need help?
General
