MAX-7 / NEO-7 - Hardware Integration Manual
UBX-13003704 - R09 Production Information Page 2 of 52
Hardware Integration Manual
Document status explanation
Document contains target values. Revised and supplementary data will be published later.
Document contains data based on early testing. Revised and supplementary data will be published later.
Early Production Information
Document contains data from product verification. Revised and supplementary data may be published later.
Document contains the final product specification.
European Union regulatory compliance
MAX-7 and NEO-7 complies with all relevant requirements for RED 2014/53/EU. The MAX-7 andNEO-7 Declaration of Conformity (DoC) is
available at www.u-blox.com within Support > Product resources > Conformity Declaration.
This document applies to the following products:
u-blox reserves all rights to this document and the information contained herein. Products, names, logos and designs described herein
may in whole or in part be subject to intellectual property rights. Reproduction, use, modification or disclosure to third parties of this
document or any part thereof without the express permission of u-blox is strictly prohibited.
The information contained herein is provided “as is” and u-blox assumes no liability for the use of the information. No warranty, either
express or implied, is given, including but not limited, with respect to the accuracy, correctness, reliability and fitness for a particular
purpose of the information. This document may be revised by u-blox at any time. For most recent documents, visit www.u-blox.com.
Copyright © 2017, u-blox AG.
u-blox is a registered trademark of u-blox Holding AG in the EU and other countries
To Next Page
Loading...
Need help?
General
