MAX-7 / NEO-7 - Hardware Integration Manual
UBX-13003704 - R09 Production Information Migration to u-blox-7 modules
Page 38 of 52
6.3 Software migration
For an overall description of the module software operation, refer to the u-blox 7 Receiver Description
including Protocol Specification [4].
6.3.1 Software compatibility
u-blox 7 modules introduce a new firmware: Version 1.00. When migrating, customers should ensure that
commands used originally with u-blox 6 products are supported by the new firmware version. For information
about known limitations that could affect migration, see the u-blox 7 Firmware Version 1.0 Release Note [5].
Table 15 provides a summary of important software migration issues to note.
The configuration of the TX Ready feature has changed between MAX-6 and MAX-7 modules and is only recognized from
LEON FW 07.70 and LISA-U2 01S onwards. The MAX-6 TxD pin is mapped to PIO#5 while the MAX-7 TxD pin is mapped
to PIO#6. When communicating with u-blox cellular modules, this change of pins is not recognized by LEON FW7.60.02
and previous versions.
u-blox 6: 15 s leap second by default (FW 6.02 and FW7.0x)
u-blox 7: 16 s leap second by default
Table 15: Summary of important software migration issues
Low power modes are supported by the Power Save Mode of FW 1.0 or ROM 1.0. For migration, consult
the u-blox 7 Firmware Version 1.0 Release Note [5] and the u-blox 7 Receiver Description Including
Protocol Specification [4].
6.3.2 Messages no longer supported
This has been replaced with the more versatile CFG-TP5, which allows
for two separate time pulses and more parameters to set their function.
This has been replaced with CFG-PM2, which allows for a more
extended Power management configuration.
This has been replaced by CFG-PM2.
This has been replaced by CGF-TMODE2.
Not available in this firmware.
Not available in this firmware.
Table 16: Main differences between u-blox 6 and u-blox 7 software for migration
To Next Page
Loading...
Need help?
General
