MAX-7 / NEO-7 - Hardware Integration Manual
UBX-13003704 - R09 Production Information Product testing
Page 48 of 52
Figure 41: 1-channel GPS simulator
u-blox recommends the following Single-Channel GPS Simulators:
Spirent GSS6100 (GPS)
Spirent GSS6300 (GPS/GLONASS)
Spirent Communications Positioning Technology, www.spirent.com
8.3.1 Guidelines for sensitivity tests
1. Connect a 1-channel GPS simulator to the OEM product
2. Choose the power level in a way that the “Golden Device” would report a C/No ratio of 38-40 dBHz
3. Power up the DUT (Device Under Test) and allow enough time for the acquisition
4. Read the C/No value from the NMEA GSV or the UBX-NAV-SVINFO message (e.g. with u-center)
5. Compare the results to a “Golden Device” or a u-blox 7 Evaluation Kit.
8.3.2 ‘Go/No go’ tests for integrated devices
The best test is to bring the device to an outdoor position with excellent sky view (HDOP < 3.0). Let the
receiver acquire satellites and compare the signal strength with a “Golden Device”.
As the electro-magnetic field of a redistribution antenna is not homogenous, indoor tests are in most
cases not reliable. These kind of tests may be useful as a ‘go/no go’ test but not for sensitivity
measurements.
To Next Page
Loading...
Need help?
General
