LEA-6 / NEO-6 / MAX-6 - Hardware Integration Manual
UBX-14054794 Production Information Appendix
Page 68 of 85
Appendix
A Abbreviations
American National Standards Institute
Code Division Multiple Access
Electromagnetic compatibility
Electromagnetic interference
Electrostatic Protective Area
Global Positioning System
Global System for Mobile Communications
International Electrotechnical Commission
Table 28: Explanation of abbreviations used
B Migration to u-blox-6 receivers
Migrating ANTARIS
®
4 and u-blox 5 designs to a u-blox 6 receiver module is a fairly straightforward procedure.
Nevertheless there are some points to be considered during the migration.
Not all of the functionalities available with ANTARIS
®
4 are supported by u-blox 6. These include:
RTCM is supported in FW7.0x but not in ROM6.02 and FW6.02 versions.
UTM (Universal Transverse Mercator Projection)
B.1 Checklist for migration
Have you chosen the optimal module?
For best GPS performance (i.e. better sensitivity level and acquisition time) select a LEA-6H, LEA-6S, NEO-
6Q or NEO-6G for the advantage of TCXO performance.
If TCXO performance is not required, choose a LEA-6A or NEO-6M.
For active antenna applications, choose a LEA-6H, LEA-6S or LEA-6A, since an antenna supply circuit is
already built in or see section 1.4 and section 2.6.
For the ability to upgrade the firmware, choose a LEA-6H.
For precision timing choose a LEA-6T or NEO-6T
For dead reckoning choose a LEA-6R
To Next Page
Loading...
Need help?
General
