5. The reading of time distance between the trigger
point and the centre graticule is displayed here.
6. This icon indicates the power supply mode, i.e.:
The Oscilloscope uses battery power
The Oscilloscope uses DC adaptor power
7. The sign on the screen indicates the ground level
reference point of the waveform. If there is no sign, it
means the channel is not on.
8. 10X : This icon indicates the channel probe ratio
is set to 10 times. In operation, probe ratio must be
set to 10X if you wish to set the Oscilloscope channel
menu accordingly. Otherwise the measurement voltage
amplitude will be increased 10 times.
Bw : This icon indicates the channel bandwidth is
restricted. In other words bandwidth is 20MHz (this
function only applies to models with bandwidth over
25MHz).
9. M value indicates the main time base mode and the
applicable time base range.
UTD1000 User Manual
2. General Inspection
We suggest checking your new UTD1000 Oscilloscope
in the following steps.
1. Check the unit for possible shipping damages
If the package carton or foam plastic protective lining is
seriously damaged, please contact your Uni-T dealer or
the local Uni-T office.
2. Check the accessories
A checklist of accessories that come with your UTD1000
Oscilloscope is provided in the section “Accessories for
UTD1000 Oscilloscopes” of this user manual. Please
check any missing items against this list.
If any item is missing or damaged, please contact your
UNI-T dealer or our local office.
3. Thorough inspection of the entire unit
If the exterior of the unit is damaged, or it is not
operating normally, or it fails to pass the performance
test, please contact your UNI-T dealer or our local
To Next Page
Loading...
Need help?
General
