UNI-T UTD1000 Series User Manual


UTD1000 User Manual
12. Hiding the Menus
Use the [CLEAR/MENU] key to hide the current menu.
To display the menu, press this key again.
13. Using the Run Button
RUN/STOP
There is a [RUN/STOP] button on the front panel.
When this button is pressed your Oscilloscope stops to
acquire data. To restart data acquisition press it again.
Auto Setup :
Auto Setup can simplify operation. Press [AUTO]
and the Oscilloscope can automatically adjust the
vertical deflection factor and horizontal time base
range according to the amplitude and frequency of the
waveform, so as to ensure stable waveform display.
When the Oscilloscope is in auto setup mode, the
system setup is as shown below :
Table 2-18 Auto setup menu
Function
Acquisitionmode
Display format
SEC/DIV
VOLT/DIV
Trigger mode
Trigger level
Trigger coupling
Trigger source
Trigger slope
Trigger type
Setup
Sampling
YT
Adjusted according to signal
frequency.
Adjusted according to signal
amplitude.
Edge
Mid-point of the signal
AC
Set to A but if there is no signal
in A and a signal is applied to B,
it will be set to B.
Rising
Auto

UNI-T UTD1000 Series Specifications

General

Brand	UNI-T
Model	UTD1000 Series
Category	Test Equipment
Language	English