UAD Powered Plug-Ins Manual - 135 - Chapter 11: UAD-2 Satellite
System Sleep System sleep while UAD-2 Satellite is active is not supported. Before sleeping
the system, quit all plug-in host applications (including the UAD Meter & Con-
trol Panel) and disconnect UAD-2 Satellite. After wake, UAD-2 Satellite may
be reconnected.
Important: Quit all hosts and disconnect UAD-2 Satellite before system
sleep.
Important UAD-2 Satellite Notes
For maximum system stability and reduced possibility of data loss, please ob-
serve these requirements when operating UAD-2 Satellite:
• Due to differing architectures, “LiveTrack Mode” on page 89 is unavailable
when UAD-2 Satellite is connected. LiveTrack Mode is also unavailable with
UAD-2 PCIe cards when UAD-2 Satellite is connected to the same system as
the card(s).
• UAD-2 Satellite has a minimum hardware buffer requirement of 256 sam-
ples. The hardware buffer setting for the host and audio inter
face can be ad-
justed when UAD-2 Satellite is connected, and the UAD-2 Satellite drivers
dynamically adjust to allow for the lower buffer setting while still maintain-
ing UAD-2 Satellite's minimum buffer requirement of 256 samples.
Note: For the lowest latency while tracking, disable any plug-ins currently
running on UAD-2 Satellite from the input tracks and the monitoring and/or
master output paths.
• All devices on the FireWire bus share the available data bandwidth of the
bus, including exter
nal hard drives and audio interfaces as well as UAD
plug-ins. The amount of UAD DSP that is available for UAD plug-in process-
ing can exceed the available FireWire bandwidth. For these reasons, the
value of the “UAD Bandwidth Allocation” on page 80 setting is critical. See
“FireWire Bandwidth” on page 141 and “FireWire Bandwidth vs. UAD
DSP” on page 143 for more details.
• All three FireWire ports on UAD-2 Satellite may be used concurrently as a
FireW
ire hub, however FireWire bus power is not supplied to downstream
devices. See “Bus Power” on page 137 for details.
• See “Mixing FireW
ire Speeds” on page 140 for important information
about using FireWire 800 and FireWire 400 devices on the same bus.
To Next Page
Loading...
Need help?
General
