UAD Powered Plug-Ins Manual - 500 - Chapter 49: Boss CE-1 Chorus Ensemble
Boss CE-1 Controls
The Boss CE-1 has two operating modes, chorus and vibrato. Only one mode
can be active at a time. The operating mode is set using the Vibrato/Chorus
switch.
Clip LED The red Clip LED illuminates when signal peaks in the plug-in occur.
Normal/Effect
Switch
This is an effect bypass switch. Click to enable/disable the cho-
rus or vibrato effect. The effect that will be heard is determined
by the Vibrato/Chorus switch.
The active state is black text. The inactive state has gray text.
The default state is effect.
This is not a plug-in bypass switch. The hardware CE-1 has a slight affect on
the sound even when the effect is “bypassed” in normal mode. We have mod-
eled the plug-in faithfully and like the hardware unit, when the effect is by-
passed with this switch, audio is still processed to sound like the CE-1 in “nor-
mal” mode. To disable audio processing, use the CE-1 Power Switch.
Rate LED The yellow Rate LED blinks according to the current low-frequency os-
cillator (LFO) rate. When CE-1 is in Vibrato mode, the LFO rate is de-
termined by the vibrato rate knob. When in Chorus mode, this LED is
affected by the Intensity knob.
Note: In Chorus mode, the fastest LFO rate is slower than the slowest LFO rate
in Vibrato mode.
Vibrato/Chorus
Switch
This switch determines the operating mode of the plug-in. Click
to switch between chorus and vibrato modes.
The active mode is black text. The inactive mode has gray text.
The default mode is chorus.
To Next Page
Loading...
Need help?
General
