UAD Powered Plug-Ins Manual - 85 - Chapter 7: Using UAD Powered Plug-Ins
CHAPTER 7
Using UAD Powered Plug-Ins
Overview
Once the UAD device(s) and Powered Plug-Ins have been properly installed,
the UAD Powered Plug-Ins are accessed and used just like any host-based
plug-in. All UAD Powered Plug-Ins can run concurrently with each other and
with host-based plug-ins simultaneously, in any combination.
Most UAD Powered Plug-Ins support up to 32-bit, 192 kHz operation (excep-
tions: EMT 140, Precision Multiband, Nigel, Roland RE-201, Neve
1073SE/1081SE/33609, and Moog Multimode Filter cannot run at 176.4
kHz and above on UAD-1). Resolution is limited only the by resolution of the
host application. Please note that Powered Plug-Ins running at 96 kHz use
twice as much UAD DSP resources than those used at 48kHz, and so forth.
Launching a UAD Powered Plug-In
Each host application has its own particular methods for instantiating (launch-
ing) a plug-in. Consult the host application documentation for specific instruc-
tions on loading and using plug-ins with the application.
Cubase SX &
Nuendo SX
Figure 16. Launching a UAD Powered Plug-In in Steinberg Cubase and Nuendo
To Next Page
Loading...
Need help?
General
