WF35 EG1 or EG2 or
EL2 valve
EG1 or EG2 or EL2 valve
do not close
Replace the power
board
YES
Replace the open
valve
YES
Fix the leaking point YES
Test 3
NO
Replace the power
board
YES
NO
NO
Replace the
pres sure switch
NO
EL2 valve is the most probable cause of
this warning
Check with the
mulmeter set to V AC if the
power board supplies 230 V AC to
the water solenoids. Are the
EG1 or EG2 or EL2
supplied?
Check visually
if there is any leakage from
the cleaning circuit.
Is there any
leakage?
Test if the
pressure switch
closes the circuit with the
mulmeter set to ohm.
Does it close
Take out the
EG1, EG2 and EL2 valves
and check if they are blocked
open by blowing through
them. Are the valve
open?
F
E
E
r
L
v
v
w
w
l
C
ec
visua
if there is any leakage from
if there is anyleakage from
t
e c
eanin
circuit.
Is t
ere an
ressure switch
closes the circuit with the
m
lm
t
r
t t
hm.
D
it
l
T
k
t th
and check i
the
are blocked
o
en b
blowin
throu
h
o
en?
OVEN
Update the software with
the latest version available
and run a washing program.
SUSPENDED