5
5-7
Sending Functions
Duplex Sending
Select the type and binding of original depending on the original.
The table below lists the binding directions for each original type.
Use the procedure below to select the original type and binding direction when sending scanned originals.
1 Press the Send key.
2 Place the originals on the document processor.
3 Press the Function Menu key. Function Menu appears.
4 Press the U or V key to select [Duplex].
5 Press the OK key. Duplex appears.
6 Press the U or V key to select [1-sided] or [2-sided].
If you select [2-sided], press [Detail] (the Right Select
key), select the binding edge and press the OK key, and
then select the original setting orientation on the next
screen.
7 Press the OK key.
Completed. is displayed and the screen returns to the
basic screen for sending.
8 pecify the destination, and press the Start key to start
sending.
NOTE: Press the Reset key to reset the settings selected in
Function Menu.
Original Type Binding Binding
1-sided Sheet Original 1-sided — —
2-sided Sheet Original 2-sided Binding Left/Right,
Binding Top
Top E dge Top ,
Top Edge Left
To Next Page
Loading...
Need help?
General
