Camera settings
12.3.21 Factory Default
The Factory Default setting can be found under this path: System> Factory De-
fault.
Users can follow the instructions on this page to reset the IP Camera to factory de-
fault setting if needed.
Full Restore
Click on <Full Restore> to recall the factory default settings. The system will restart
in 30 seconds. The IP address will be restored to default. After the system is re-
started, reconnect the camera using the default IP address. The default IP address
is 192.168.0.10.
Partial Restore
Click
on
<Partial
Restore>
to
recall
the
factory
def
ault
settings.
T
he
system
will
re-
start in 30 seconds. Refresh the browser page after the system is restarted.
NOTE: The IP address will not be restored to default.
Reboot
Click on <Reboot> and the system will restart without changing current settings.
Refresh the browser page after the system is restarted.
12.3.22 Software Version
The Software Version can be found under this path: System> Software Version.
The current software version is displayed in the software version page.
12.3.23 Software Upgrade
The Software Upgrade setting can be found under this path: System> Software
Upgrade.
NOTE: Make sure the upgrade software file is available before carrying out soft-
ware upgrade.
The procedure of software upgrade is as below.
Step 1. Click on <Browse> and locate the upgrade file, for example “uI-
mage_userland”.
NOTE: Do not change the upgrade file name, or the system will fail to find the file.
Step 2. Pick a file type from the drop-down list. In this case, select “uI-
mage+userland.img”
Step 3. Click on the <Upgrade> button. Then the system will prepare to start the
software upgrade. Subsequently, an upgrade status bar will be dis-
played on the page to show the current upgrade process. After the up-
grade process is finished, the viewer will return to home page.
Step 4. Close the video browser.
Step 5. Click on <Start> and enter the <Control Panel>. In the appeared window,
double click on <Add or Remove Programs>. A window with the <Cur-
rently install programs> list will popup. In the list, select <Vander-
To Next Page
Loading...
Need help?
General
