1. Introduction
1.1 Manufacturer's Liability
As the manufacturer, VATECH assumes liability for the safe and reliable installation
and operation of this equipment only when:
▪ Equipment installation, including software installation, was carried out by an
authorized agent by this installation manual.
▪ The electrical installation was carried out by the appropriate requirements
specified in IEC-60363.
▪ Genuine original or approved replacement parts are used.
▪ Maintenance/repair service has been performed by a qualified technician(s) from
one of our authorized agents.
▪ The equipment has been used under a normal condition by the user's manual.
▪ PC Software has been properly used by the manufacturer’s installation
instructions and user manuals.
1.2 Customer’s Responsibility
Site planning and preparation are the responsibility of the customer. The following
points should be considered fundamentally important to all customers of this product:
▪ Install all required materials prior to delivery of the system.
▪ Complete the floor, ceiling, and walls of the room before installing the equipment.
▪ Install proper sized junction boxes, with covers, at the necessary locations.
▪ Install a mains power with the proper voltage output and an adequate kVA rating.
▪ Install the circuit breaker specified by this manual.
▪ Provide the installer(s) with the current dimensions of the room including the
hallway and entry door sizes.
▪ The customer must have an electrician install more than two power outlets in the
room.
To Next Page
Loading...
Need help?
General
