Vega VEGABAR 38 User Manual

48
10 Diagnostics and servicing
VEGABAR 39 • Three-wire 1 x transistor or 4 … 20 mA
57536-EN-200831
Code
Text message
Cause Rectication
F110
Switching points too close to-
gether
Selected switching points too close to-
gether
Increase the distance between the
switching points
F111
Switching points inter-
changed
Switching point 1 is smaller than switch-
ing point 2
Increase switching point 1 to greater
than switching point 2
F260
Error in the calibration
Checksum error in the calibration val-
ues
Send instrument for repair
F261
Error in the instrument set-
tings
Checksumerrorintheconguration
values
Carry out a reset
Code
Text message
Cause Rectication
C700
Simulation active
A simulation is active Finish simulation
Wait for the automatic end after
60 mins.
Code
Text message
Cause Rectication
S600
Impermissible electronics
temperature
Temperature of the electronics in the
non-speciedrange
Check ambient temperature
Insulate electronics
S604
Switching output overloaded
Overload or short circuit at output 1 or 2 Electrical connection, check load re-
sistance
Code
Text message
Cause Rectication
M504
Error at a device interface
Interference of the internal communica-
tion to Bluetooth
Restart
Send instrument for repair
M510
No communication with the
main controller
Fault in internal communication with the
display
Restart
Send instrument for repair
10.5 Software update
The device software is updated via Bluetooth.
The following components are required:
•
Instrument
•
Voltage supply
•
PC/notebook with PACTware/DTM and Bluetooth USB adapter
Function check
Outofspecication
Maintenance

Vega VEGABAR 38 Specifications

General

Brand	Vega
Model	VEGABAR 38
Category	Accessories
Language	English