Engine oil level
In 4T engines, engine oil is used to lubricate the distribution elements, main bearings
and thermal group. An insufficient quantity of oil can cause serious damage to
the engine itself. In all four-stroke engines, a loss of efficiency in oil performance and
consumption should be considered normal. Consumption can particularly reflect the
conditions of use (i.e. when driving at "full acceleration" all the time, oil consumption
increases). The replacement frequencies provided for by the maintenance programme
are defined, depending on the total contents of oil in the engine and average con-
sumption measured following standardised methods. In order to prevent any prob-
lems, we recommend checking oil level more frequently than indicated in the
Scheduled Maintenance table or before setting off on long journeys. The vehicle
is, however, equipped with an oil pressure warning light on the instrument pan-
el.
03_01
Engine oil level check (03_01)
Every time the scooter is used, a visual check should be made on the level of the
engine oil when the engine is cold. The oil level should be somewhere between the
MAX and MIN index marks on the level bar; the check must be made with the scooter
upright, resting on the centre stand. If the check is carried out after the vehicle has
been used, and therefore with a hot engine, the level line will be lower; in order to carry
out a correct check, wait at least 10 minutes after the engine has been stopped so as
to get the correct level.
Engine oil top-up
Always check oil level before topping-up and add oil without exceeding the MAX
level. Getting an oil level between the MIN and MAX levels requires ~ 400 cm³ of oil.
Take your vehicle to an Authorised Service Centre to have the engine oil checked
and if necessary, topped-up as indicated in the scheduled maintenance table.
38
To Next Page
Loading...
Need help?
General
