DISPLAY CAUSE SOLUTION
GROUP PROBE X
ERROR
This error signals a problem on the
X unit probe.
t 4IPVME$$
CFTIPXOJUNFBOT
the X unit probe shorted.
t 4IPVME/$CFTIPXOJUNFBOT
the X unit probe is not con-
nected or the control unit sees
it as not connected.
t $IFDL DPOOFDUJPOT BOE WFSJGZ
values detected by the probe
using a tester. Replace, if nec-
essary.
BOILER PROBE X
ERROR
This error signals a problem on the
X heater probe.
t Should CC be shown, it means
the X heater probe shorted.
t Should NC be shown, it means
the X heater probe is not con-
nected or the contr
ol unit sees
it as not connected. Check
connections and verify values
detected by the probe using a
tester. Replace, if necessary.
WASHING ALARM
It signals the need to wash the
units, as the washing alarm thresh-
old was exceeded.
Wash all units. Check settings on
Technical settings.
ERROR OF NOT
-
COMPATIBLE CON-
TROL UNIT
It signals the machine control unit
is not compatible with the display
it is connected to. Refer to the
document of compatibility of the
versions.
Install a compatible contr
ol unit or
carry out the necessary updates
(link on the table).
TABLE OF ERROR AND ALARM MESSAGES
SERVICE MANUAL
9.4
Edition 01 of 08/2017
Italiano English Francais Deutsch Espanol
"Allarme manutenzione" "Maintenance alarm", "Alarme entretien", "Alarm Wartung", "Alarma mantenimiento",
"Allarme pila" "Battery alarm", "Alarme pile", "Alarm Batterie", "Alarma pila",
"Errore scrittura EEPROM" "EEPROM write error", "Erreur écriture EEPROM", "Fehler Speichern EEPROM", "Error escritura EEPROM",
"Errore lettura RTC" "RTC read error", "Erreur lecture RTC", "Fehler Auslesen RTC", "Error lectura RTC",
"Errore scrittura RTC" "RTC writ
e error", "Erreur écriture RTC", "Fehler Speichern RTC", "Error escritura RTC",
"Errore dosatura gruppo" "Group dose error", "Erreur dosage groupe", "Fehler Dosierung Brühgr.", "Error dosificación grupo",
"Errore erogazione gruppo" "Group pour error", "Erreur extraction groupe", "Fehler Ausgabe Brühgr.", "Error dispensación grupo",
"Errore pressione" "Pressure error", "Erreur pression", "Fehler Druck", "Error presión",
"Errore livello" "Level error", "Erre
ur niveau", "Fehler Füllstand", "Error nivel",
"Errore pressostato caldaia" "Boiler pressure switch error", "Erreur pressostat chaudière", "Fehler Drucksch. Boiler", "Error presostato caldera",
"Errore sonda scaldatazze 1" "Cup warmer probe 1 error",
"Erreur sonde chauffe-tasses 1", "Fehler Sonde Tassenwärmer 1", "Error sonda calienta-tazas 1",
"Errore sonda scaldatazze 2" "Cup warmer probe 2 error", "Erreur sonde chauffe-tasses 2", "Fehler Sonde Tassenwärmer 2", "Error sonda calienta-tazas 2",
"Errore comunicazione seriale" "Serial coms error", "Erreur communication série", "Fehl.Kommun.serielle Schnittst", "Error comunicación serial",
"Errore sonda vapore 1 CC" "CC steam probe 1 error", "Erreur sonde vapeur 1 CC", "Fehler Dampfsonde 1 CC", "Error sonda vapor 1 CC",
"Errore sonda vapore 2 CC" "CC steam probe 2 error", "Erreur sonde vapeur 2 CC", "Fehler Dampfsonde 2 CC", "Error sonda vapor 2 CC",
"Errore sonda gruppo 1" "Group probe 1 error", "Erreur sonde groupe 1", "Fehler Sonde
Brühgr. 1", "Error sonda grupo 1",
"Errore sonda gruppo 2" "Group probe 2 error", "Erreur sonde groupe 2", "Fehler Sonde Brühgr. 2", "Error sonda grupo 2",
"Errore sonda gruppo 3" "Group probe 3 error", "Erreur sonde groupe 3", "Fehler Sonde Brühgr. 3", "Error sonda grupo 3",
"Errore sonda gruppo 4" "Group probe 4 error", "Erreur sonde groupe 4", "Fehler Sonde Brühgr. 4", "Error sonda grupo 4",
"Errore sonda caldaia 1" "Boiler probe 1 error", "Erreur sonde chaudière
1", "Fehler Sonde Boiler 1", "Error sonda caldera 1",
"Errore sonda caldaia 2" "Boiler probe 2 error", "Erreur sonde chaudière 2", "Fehler Sonde Boiler 2", "Error sonda caldera 2",
"Errore sonda caldaia 3" "Boiler probe 3 error", "Erreur sonde chaudière 3", "Fehler Sonde Boiler 3", "Error sonda caldera 3",
"Errore sonda caldaia 4" "Boiler probe 4 error", "Erreur sonde chaudière 4", "Fehler Sonde Boiler 4", "Error sonda caldera 4",