Use gloves to protect against sharp or hot sur-
faces that you can bump against involuntarily
during operations.
NOTE
Before proceeding with the removal of the
panels it is advisable to clean and free up
enough space where the machine parts will
rest so that they are not be unintentionally
damaged.
3.1 REMOVAL OF THE CUP
HOLDER SURFACE
To remove the modular cup warming tray:
DANGER
Before proceeding with the operations
described in the chapter make sure that the
machine is turned off and unplugged from the
mains. Discharge any residual pressure pre-
sent in the steam heater.
2 Disconnect the temperature probe of the
cup warmer and remove all panels.
1 Unscrew the 3 screws for each module with
a Phillips screwdriver that is located under
the left panel.
Edition 01 of 08/2017
3.2
SERVICE MANUAL
CUTTING
AND
HOT
SURFACES
Fig. 57
DANGER
Fig. 58
Fig. 59
Fig. 60
To Next Page
Loading...
Need help?
General
