Position the tip at the point indicated in the figure
while dispensing, considering that the hot water
and cold water valves are in parallel, just verify
the operation of this relay to check both valves.
HOW TO ACCESS THE VALVES
To safely access the valves it is necessary to:
1 Open the steam taps until all the steam is
released.
NOTA
It is not possible to operate with pressure in
the heater.
2 Turn off and disconnect the power to the
machine.
3 Remove the first cup warmer module on the
left, unscrew the Phillips screw, disconnect
the power supply to the cup warmer and
remove the probe.
4 Remove the work surface and close the
water entrance near the pump.
Edition 01 of 08/2017
7.17
SERVICE MANUAL
Fig. 231
Fig. 232
Fig. 233
Fig. 234
To Next Page
Loading...
Need help?
General
