PAGE 22 of 32 DIGITAL GSM INTERCOM TECHNICAL MANUAL VER2.1.1
1111STTn:”yyyyyyyyyy” Change the name to yyyyyyyy for apartment n. n can be
1-6 digits.
1111STTn:”yyyyyyyyyy”? Change the code yyyyyyyy in apartment n and send a
confirmation text message to confirm the storage of the
new name.
1111STTn:? Query the name stored for apartment n. A text message
will be sent to the sender with the stored code for that
apartment.
1111STTn:”” Delete the name stored for apartment n.
1111STTn””? Delete the name stored for apartment n. A text message
will be sent to the sender with the delete confirmation for
that location.
NOTE: IF A SPACE IS REQUIRED ON THE DISPLAY SUBSTITUE IT WITH THE CHARACTER ‘>’ IN THE SMS MESSAGE. THIS
IS BECUASE SPACES IN THE SMS MESSAGE ARE DISCARDED.
ADD A NEW APARTMENT OR QUERY A MEMORY LOCATION (MEM)
There are 1000 memory locations available in the Digital panel (000-999). Each of these
memory locations stores apartment’s settings. It is possible to query change or add an
apartment using the following command:-
1111MEMnnn? Query a memory location. A text message will be
returned with all the settings for that apartment. nnn =
memory location 000-999
1111MEMnnn”yyyyyyyyyy”,”zzzzzzzzzz”,”aaaaaa”,”cccccc”,d,b,”tttttttttt”?
nnn = Memory location 000-999
yyyyyyyyyy = Primary telephone number
zzzzzzzzzz = Divert telephone number
aaaaaa = Apartment number from 1-6 digits
cccccc = Access code from 1-6 digits
d = Dial to open setting, 1 = enabled, 2 = disabled
b = Time band, 0-9
ttttttttt = Apartment name, 1 to 16 characters.
The ? is optional
NOTE: Using this command it is possible to change all or only some of the apartments
settings. To leave a setting unchanged simply don’t enter anything in that section of that
setting but remember to add the comma.
For example to change everything except the apartment number send:-
1111MEMnnn”yyyyyyyyyy”,”zzzzzzzzzz”,,”cccccc”,d,b,”tttttttttt”?
To change only the primary and divert number send:-
1111MEMnnn”yyyyyyyyyy”,”zzzzzzzzzz”,,,,,?
SET CALL TIME (SPT)
The call time is the maximum time in seconds that a call can last before the intercom panel
automatically clears the call down. The time can be from 1 seconds up to 255 seconds
To Next Page
Loading...
Need help?
General
