Viscosity
Select the viscosity according to the table.
The temperature values refer to stable ambient tem-
peratures.
* SAE 5W/30 refers to synthetic or semi-synthetic oils.
Fuel System
Fuel specification
The fuel must comply with national and international standards for commercially supplied fuels, such as:
EN 590 (with national environment and cold requirements)
ASTM D 975 No 1-D and 2-D
JIS KK 2204
Sulfur content: Complying with legal requirements in each country.
Low density fuel (urban diesel in Sweden and city diesel in Finland) can cause a loss of up to 5% of power and
an increase in fuel consumption of about 2–3%.
Cooling System
Freshwater system capacity including heat exchanger, approx. 39 liters (10.3 US gals).
Water Quality
ASTM D4985:
Total solid particles <340 ppm
Total hardness <9,5° dH
Chloride <40 ppm
Sulfate <100 ppm
pH value 5,5–9
Silica (acc. ASTM D859) <20 mg SiO
2
/l
Iron (acc. ASTM D1068) <0,10 ppm
Manganese (acc. ASTM D858) <0,05 ppm
Conductivity (acc. ASTM D1125) <500 µS/cm
Organic content, COD
Mn
(acc.
ISO8467)
<15 mg KMnO
4
/l
To Next Page
Loading...
