Faults list
Is a fault registered the display shows Faults in the
EVC menu along with the number of faults.
Push the knob on the control panel to open the menue.
Turn the knob to see all faults registred.
The popup toggles between cause of fault and tasks
to perform.
Erasing faults in faults list
Acknowledged faults that has been stored automati-
cally erased every time the starter key is turned to the
stop position (S).
Stop the engine and check that the ignition key(s) is
(are) in position 0 in all control positions.
When system voltage is switched on again, the diag-
nostic function checks whether there are faults in the
EVC system. If this is the case, new fault pop-ups are
shown.
Faults which have been attended to or have disap-
peared are automatically erased.
Faults which have not been attended to must be
acknowledged every time the system voltage is
switched on.
To Next Page
Loading...
Need help?
General
