Draining:
1 Close the sea cock.
2 Connect a hose to each drain tap before opening
the tap (one at a time).
3 Open the drain taps/remove the drain plugs (S) and
allow the water to run out.
Drain points:
- tap at rear of heat exchanger
- tap at rear of charge air cooler
- Open the drain taps/remove the drain plugs (S)
and allow the water to run out.
Check that all water really does drain out. Depos-
its may need to be cleared away, inside the drain
plug/tap.
4 Also drain/empty any auxiliary equipment such as
the seawater filter, flushing/bilge pump etc.
5 Install the lid on the flushing/bilge pump if fitted.
Connect all hoses.
6 Close/install all drain taps and plugs before you
leave the boat.
7 Check for leaks before you leave the boat.
Zinc Anodes, Check and Change
WARNING!
Risk of water entry. Close the seawater cocks before
doing any work on the seawater system.
Maintenance
76 7748887 04-2008
To Next Page
Loading...
Need help?
General
