IMPORTANT!
Observe the instruction manual for the battery charger
carefully. To avoid the risk of electrochemical corrosion
when an external charger is connected, the battery
cables should be removed from the batteries before
the charger is connected.
Always switch off the charging current before the
charging clips are removed.
•
Charge batteries if they have become discharged.
During charging, unscrew the cell plugs but leave
them min the plug holes. Ventilate well, especially if
the batteries are charged in an enclosed space.
•
If the engine is not used for a longer period of time,
the batteries should be fully charged, then possibly
trickle charged (please refer to the battery manu-
facturer’s recommendations). Batteries are dam-
aged by being left discharged, and can also freeze
and burst easier in cold weather.
•
Special instructions apply to boost charging. Boost
charging can shorten battery life, and should there-
fore be avoided.
Electrical Installations
An incorrectly-carried-out electrical installation may
generate leakage current from the electrical system.
Leakage current can in turn render galvanic protection
insufficient in respect of propellers, propeller shafts,
rudder posts, keel etc and may cause damage through
electrochemical corrosion.
WARNING!
Work on the low voltage circuits in the boats should be
done by a person with electrical training or knowledge.
Installation or work on land current equipment must
only be done by a competent electrician, in accordance
with local regulations for mains electricity.
To Next Page
Loading...
Need help?
General
