Volvo Penta D2-55 Workshop Manual

55
Oil pump bearing, overhaul
Special tools: 384 9641
In order to remove the oil pump, the timing gear and
crankshaft must be removed.
2. Use tool 384 9641. First screw the tool’s guide
pin (1) into the engine block.
Then put the new oil pump bearing (2) into the
tool block (3).
1. Drive out the oil pump bearing section (1) located
in the engine block. Tap it out from inside the
crankcase.
3. Place the tool block with the bearing in place, us-
ing the guide pin.
Tap in the bearing until the tool bottoms on the
engine block.
NOTE! It is important that the engine block sur-
face towards the tool is clean and even.

Volvo Penta D2-55 Specifications

General

Engine Type	Diesel
Number of Cylinders	4
Power Output	55 hp
Aspiration	Naturally aspirated
Alternator	115 A
Fuel System	Direct injection
Bore x Stroke	84 mm x 100 mm
Cooling System	Freshwater cooling with heat exchanger
Width	523 mm
Displacement	2.2 l (134 cu in)