Oil Sensor Reset
OceanX (OX) drives only
Whenever the drive oil is replaced, the drive oil sensor
must be reset. If your dealer changed the oil in the
drive, the sensor should already have been reset.
However, if you changed the drive oil yourself, or if the
dealer forgot to reset the sensor, the alarm may sound.
If this occurs, you can reset the sensor yourself by
using the following steps:
WARNING!
Risk of accidental engine starting. Key must be in
ignition and engine electrical power turned on to
perform this procedure. Tag each starting position to
alert others that service is being performed on the
drives and the engines must not be started.
The boat/drive must be out of the water for this
procedure.
1 Trim the drive so that the cavitation plate is level.
2 Allow the drive oil to settle for at least 30 minutes.
3 Using a 12 mm socket, remove the five shift cover
screws. Remove the shift cover.
4 Insert the key into the ignition switch O. Turn the
key one step to the right I to switch on engine
electrical power. Do not start the engine.
5 Move the plastic protector A off of the oil sensor
connector B.
6 Press the release on the connector and pull the plug
out of the sensor.
7 Wait at least three seconds. Plug the connector
back in.
8 The engine alarm will sound three beeps to
acknowledge that the sensor has been reset.
9 Reinstall the cover and screws, torque screws to
17–23 Nm (13–17 ft. lb.).
P0018309
51735
Maintenance
47712779 09-2020 © AB VOLVO PENTA 99
To Next Page
Loading...
Need help?
General
