Engine, General
Serpentine Belt
WARNING!
Extreme crush and pinch hazard from belts, pulleys,
and moving parts. Engine should be turned off before
starting service or maintenance work.
Stop the engine before inspecting or servicing a belt.
Loose clothing, hair, fingers or a dropped tool can be
caught in the rotating parts of the engine and cause
serious personal injury.
The alternator and engine circulation pump are
powered by a serpentine drive belt A that is driven by
the crankshaft pulley F and is routed around the
automatic belt tensioner B, alternator pulley C, idler
pulleys D and circulation pump pulley E.
Procedures for inspecting the belts are covered in the
Service and Maintenance Manual.
Lubrication System
Scheduled Oil Service
For a schedule of oil change intervals, refer to the
Service Protocol.
Volvo Penta recommends the use of our gasoline
engine oils whenever performing oil service. Contact
your dealer for the correct engine oil.
If Volvo Penta oil is not available an alternative oil can
be used as long as it meets the Engine Oil
Specifications, page 107.
Always change the oil filter every time the oil is
changed.
To ensure the engine oil is filled to the correct level, the
level must always be checked on the dipstick. This
includes refilling the crankcase as part of changing the
engine oil.
Checking Engine Oil Level
During the break-in period, slightly higher oil
consumption is possible. Check the oil level before
every trip. See Engine Break-in: Gasoline Engines
(publication number 47700022) that came with your
engine.
P0018336
P0019973
P0016601
Maintenance
86 47712779 09-2020 © AB VOLVO PENTA
To Next Page
Loading...
Need help?
General
