D
Group 177 Preventive Maintenance
W6000848
1
Chassis Lubrication
Note: Chassis lubrication should be performed every four
months including the annual lubrication.
Front Axle Steering Knuckles
Volvo: Two grease fittings on each side-one on the top
knuckle cover (fill with grease until the old grease is forced
out past the top seal), one on the bottom cover (fill with
grease until the old grease is forced out past the bottom
seal).
Note: Lubrication of the Volvo axle should be done with
the wheels on the ground!
W6000850
Note: Before performing preventive maintenance on
Meritor or Eaton Front Axle components, please refer
to the appropriate vendor service literature for specific
instructions.
Meritor and Eaton: Raise the axle so the wheels are
off the ground before attempting to grease the steering
knuckles.
Two grease fittings on each side-one on the top knuckle
cover, fill with grease until the old grease is forced out
past the top seal; one on the bottom cover, fill with grease
until the old grease is forced out past the bottom seal.
W6000869
Steering Linkage
Steering shaft and draglink are lubed for life. Tie-rod for
Volvo front axles are lubed for life.
Meritor and Eaton front axle tie-rods need to lubricated.
Fill tie-rod end with grease until old grease is forced out
past the rubber boot and only uncontaminated grease
is visible.
34
To Next Page
Loading...
Need help?
General
