52
Voice guide to set Answering
system
This feature is an alternative way for you
to do the basic setup of the answering
system. You can follow the voice guide to
record your own announcement, set the
number of rings, and set the message alert
tone.
1. Press MENU on the cordless handset in
idle mode to enter the main menu.
2. Press q or p to choose Answering sys
and then press SELECT.
3. Press q or p to choose Voice guide
and then press SELECT. You hear a
voice prompt, “This voice guide will
assist you with the basic setup of your
answering system.“
4. Setup your answering system by
inputting designated numbers, as
instructed in the voice guide.
• You can press CANCEL on the cordless
handset to quit the voice guide at any time.
• After a power outage, the system prompts
you to set the date and time, and Smart call
blocker. After these settings are done or
skipped, the system prompts if you want to
set up the answering system via voice guide.
Press SELECT to start the setup.
Set number of rings
You can set the answering system to
answer an incoming call after two, three,
four, five or six rings; or toll saver.
If you choose toll saver, the answering
system answers a call after two rings when
you have new messages, or after four rings
when you have no new messages. This
enables you to check for new messages
and avoid paying unnecessary long
distance charges if you are calling from
outside your local area.
1. Press MENU on the cordless handset in
idle mode to enter the main menu.
2. Press q or p to choose Answering sys
and then press SELECT.
3. Press q or p to choose Ans sys setup
and then press SELECT.
4. Press q or p to choose # of rings and
then press SELECT.
5. Press q or p to choose 6, 5, 4, 3, 2 or
Toll saver and then press SELECT to
save. You hear a confirmation tone.
Set recording time
You can set the recording time for each
incoming message.
1. Press MENU on the cordless handset in
idle mode to enter the main menu.
2. Press q or p to choose Answering sys
and then press SELECT.
3. Press q or p to choose Ans sys setup
and then press SELECT.
4. Press q or p to choose Recording
time and then press SELECT.
5. Press q or p to choose 3 minutes,
2 minutes or 1 minute, and then
press SELECT to save. You hear a
confirmation tone.
To Next Page
Loading...
Need help?
General
