59
Expand your telephone
system
Add and register expansion
handset
You can add new cordless handsets
(SN5107, purchased separately) to expand
your telephone system. Your telephone
base supports a maximum of four cordless
handsets.
Additional handsets are assigned numbers
in the sequential order.
Charge the new handset without
interruption for at least 30 minutes before
registering it to he telephone base.
After charged, each expansion handset
displays To register HS, see manual.
• You cannot register a handset if any other
system device is in use.
• Only one handset can register to the
telephone base at a time.
To register a SN5107 handset:
1. When the telephone is not in use,
press and hold PAGE at the telephone
base for about five seconds until the
visual ringer indicator light turns on.
Release PAGE.
2. Press the pound (#) key on the
handset. The handset displays
Registering... Please wait.
The handset show Registered and you
hear a beep when the registration process
completes. The registration process takes
about 60 seconds to complete.
If the registration fails, the handset displays
Registration failed, and then To register
HS, see manual. Remove the handset from
the charger and repeat the registration
process again.
Add and register photo speed dial
handset
You can add a new photo speed dial
handset (SN5307, purchased separately)
to your telephone system. The SN5307
cordless photo speed dial handset lets you
quickly dial one of the four preset numbers
by just pressing the photo speed dial key.
If you have already set the photo
speed dial keys 1, 2, 3 and 4 on the
telephone base, the same numbers will
be automatically set for the dial keys of
your newly registered photo speed dial
handset.
You can register a maximum of four
cordless handsets.
• You cannot register a handset if any other
system device is in use.
• Only one handset can register to the
telephone base at a time.
To register a SN5307 handset:
1. When the telephone is not in use,
press and hold PAGE at the telephone
base for about five seconds until the
visual ringer indicator light turns on.
Release PAGE.
2. Put the handset in its charger. The
handset CHARGE light alternates red
and green quickly to indicate the
registration is in progress.
You hear a beep when the registration
process completes. The registration
process takes about 60 seconds to
complete.
If registration fails, you hear an error tone,
and the CHARGE light alternates red and
green slowly when it is taken out of the
charger. Start again from Step 1 above.
To Next Page
Loading...
Need help?
General
