61
To register an Audio doorbell:
1. When the telephone is not in use,
press and hold PAGE at the telephone
base for about five seconds until the
visual ringer indicator light turns on.
Release PAGE.
2. Press and hold the pair button on the
back of the audio doorbell until the
chime button LED light flashes, then
release the button. When registration
is successful, the chime button LED
light becomes steady on, and then the
base beeps once.
It takes up to 60 seconds to complete
the registration. When the registration is
successful, the chime button LED light on
the front of the Audio doorbell turns to
steady on, and the telephone base beeps
and its visual ringer indicator light turns off.
If registration fails, start again from Step 1
above.
For detailed installation and operation
instructions, refer to the Audio doorbell
section in this user’s manual, and the user’s
manual of your Cordless audio doorbell.
To register a Wearable home SOS
pendant:
1. When the telephone is not in use,
press and hold PAGE at the telephone
base for about five seconds until the
visual ringer indicator light turns on.
Release PAGE.
2. Press and hold CANCEL on the back
of the SOS pendant until the LED light
on the front flashes, then release the
button. When registration is successful,
the LED light turns off, and then the
base beeps once.
It takes up to 60 seconds to complete
the registration. When the registration is
successful, the red LED lights on the SOS
pendant turns off, and the telephone base
beeps and its visual ringer indicator light
turns off.
If registration fails, start again from Step 1
above.
For detailed installation and operation
instructions, refer to the SOS emergency
call section in this manual, and the user’s
manual of your Wearable home SOS
pendant.
To Next Page
Loading...
Need help?
General
