BA 50Z3/6003 en – Edition 4.3 * 5003b330.fm 3-69
Operation
3.43 Crane handling the machine
Incorrect crane and lifting gear operation –
Risk of accidents.
☞ All equipment (crane, lifting gear, etc.) required for loading must be:
• certified, suitable and of adequate size.
• positioned and fastened correctly.
• free of damage and wear.
• Necessary recurrent inspections must not be overdue.
☞ Observe all international, national and possible in-house regulations and
guidelines on loading.
☞ Have crane operators guided only by experienced persons that know the
required crane signals.
☞ The person guiding the crane operator must be within sight or sound of him.
Incorrect fastening of lifting gear on the machine –
Risk of accidents.
☞ Have only experienced persons attach lifting gear.
☞ Use only the lifting points provided to this effect and marked accordingly for
attaching lifting gear.
☞ Perform a visual check to ensure that all lifting points are in good condition.
☞ If the machine is raised by means of the cab, a crane-handling bracket or
similar, check the screws and nuts of these components for tightness and
correct torque before attaching lifting gear to them.
☞ Use only suitable lifting gear (hooks, shackles, for example) on the
machine.
☞ Do not place the lifting gear over sharp edges.
☞ Ensure that the lifting gear has the required lengths.
To Next Page
Loading...
Need help?
General
