BA 50Z3/6003 en – Edition 4.3 * 5003b510.fm 5-1
Maintenance
5 Maintenance
5.1 Introduction
Operational readiness and the service life of machines are heavily dependent on maintenance.
It is therefore in the interest of the machine owner to perform the mandatory maintenance work.
Bear in mind the following points before performing service and maintenance work:
• Chapter 2 “SAFETY INSTRUCTIONS” of this Operator’s Manual
• The Operator’s Manuals of the attachments.
Perform the prescribed inspections and rectify any disorders immediately before putting
the machine into operation, or have them rectified by an authorized workshop. Secure the
open engine cover and other open covers appropriately. Do not open the engine cover and
other covers on slopes or in strong wind.
When using compressed air, dirt and debris can be blown into your face. Therefore, wear
safety glasses, protective masks and clothing when using compressed air.
5.2 Safety-relevant parts
Service and maintenance work must be performed by a specifically trained person.
All other maintenance work that is not indicated in this Operator’s Manual must be per-
formed only by the trained and qualified personnel of a Wacker Neuson workshop.
The following maintenance plans indicate the maintenance work to be performed.
This is necessary to ensure optimal functioning. – see Maintenance plan (overview) on
page 5-57.
Immediately repair or replace parts that are already damaged or not working properly
before they are due for replacement.
Safety-relevant parts may only be repaired or replaced by a Wacker Neuson
dealer or a Wacker Neuson workshop.
Parts Interval
Hydraulic hoses
Replace hydraulic hoses every 6 years from the
date of manufacture, even if they do not seem
to be damaged.
Bladder type accumulator
Must be checked by a Wacker Neuson dealer
every 2 years.
Seat belt
No replacement necessary. Replace the seat
belt after an accident.
To Next Page
Loading...
Need help?
General
