30
OPERATING MANUAL
VERSION 05/2017 ORDER NUMBER DOC 2354920
SPRINT XE
6.4 ASSEMBLING THE MANUAL SYSTEM
6.4.1 ASSEMBLING THE EQUIPMENT TROLLEY
The manual system's trolley is supplied unassembled for transport reasons. It must be
assembled as described below.
2
1
P_02643
25Nm;
18.44lb ft
3
Procedure:
1. Open transport packaging with care
and carefully take all single parts out of
packaging.
2. Place lower trolley section (1) on a clean,
level surface.
3. Place upper trolley section (2) on the two
guide sleeves on the lower trolley section
(1), press down gently until stop is reached
and use nuts and bolts (see detail) to screw
to lower trolley section (tightening torque
25 Nm; 18.44 lb/ft).
4. Mount the gun holder (3) (see separate
assembly manual).
6.4.2 ASSEMBLING THE CONTROL UNIT
1
2
3
P_02644
4
Procedure:
1. Carefully take control unit (1) out of
packaging and use the supplied screws (2)
to screw into the holes drilled in the angle
bracket (3).
Mount the control unit such that it is ush
with the cover at the front.
To Next Page
Loading...
Need help?
General
