46
OPERATING MANUAL
VERSION 05/2017 ORDER NUMBER DOC 2354920
SPRINT XE
7.5.2 60 L TANK VERSION
7.5.2.1 CLEANING PROCESS WHEN USING A SINGLE POWDER TANK
Note:
For a paint change, all components of the powder feed system must be thoroughly cleaned.
P_01785
EPG
SPRINT X
0
%
10
20
30
40
50
Ø
12
10
11
9
8
m /h
2.0
3.0
0.5
0.3
0.1
1.5
3
5.5
4.5
3.5
2.5
80
100
%
Tri
90
60
70
17
Procedure:
1. Release the trigger on the spray gun.
The high voltage and the powder feed are
deactivated.
2. Remove the injector from the holder to stop
powder feed.
3. Hold the gun in the spray booth and start the
ush function by pressing the "Flush" button (17).
The injector and hoses are ushed.
4. Switch o control unit.
5. Open the powder tank and clean all powder
feeding parts of the unit,
such as the spray gun, the injector, the powder
feed hose and the suction system.
6. Clean the powder tank and pay special attention
to the uid base.
Note:
Proper uidization is not possible with a damaged
and/or clogged uid base.
To adapt the programs to the new applications proceed as described in the EPG-Sprint XE
control unit's operating manual.
To Next Page
Loading...
Need help?
General
