43
OPERATING MANUAL
VERSION 05/2017 ORDER NUMBER DOC 2354920
SPRINT XE
7.4 INTERRUPTING THE COATING PROCESS
7.4.1 AIRFLUID VERSION
NOTICE
Powder residues and sticking uid disk!
Equipment damage and danger of blockage.
Before the control unit is deactivated, the feed unit must be pulled out of the powder
tank.
At every work interruption, blow through the spray gun and the powder feed
components and clean from any powder residues.
P_01785
EPG
SPRINT X
0
%
10
20
30
40
50
Ø
12
10
11
9
8
m /h
2.0
3.0
0.5
0.3
0.1
1.5
3
5.5
4.5
3.5
2.5
80
100
%
Tri
90
60
70
P_1789
H
17
Procedure:
1. Release the trigger on the spray gun.
The high voltage and the powder feed are
deactivated.
2. Lift the feed unit up, underneath the injector,
and lift it out of the tank until retaining clamp
(H) swivels downwards.
3. Lower the feed system into the parking position
and swivel it to the right side so that no more
powder is forwarded.
4. Hold the gun in the spray booth and start the
ush function by pressing the "Flush" button (17).
The injector and hoses are ushed.
5. Now the control unit can be switched o .
To Next Page
Loading...
Need help?
General
