40
OPERATING MANUAL
VERSION 05/2017 ORDER NUMBER DOC 2354920
SPRINT XE
7.2.2 ADJUSTING THE FLUIDIZATION (AIRFLUID)
P_02640
1
2
Procedure:
1. Swivel the feed unit (1) to the right side.
2. Place an opened powder tank (25–30 kg; 55.11–
66.14 lbs) on the vibrator table.
3. Switch on the control unit.
4. Swivel the feed system (1) into the powder tank
and lower it down to the powder surface. Actuate
the trigger of the spray gun for a short time and
release it. The vibrator motor and the uid air
overrun for 10 s (factory setting). This setting
can be changed by the user if required (see EPG-
Sprint XE control unit operating manual).
5. Adjust the uid air at the throttle (2) to the
point that it makes the feed system sink into the
powder due to its own weight.
Note:
– The amount of uid air depends on the
characteristics of the powder.
– The powder should be moving in the suction
area of the feed unit (gently simmering).
– Avoid a dust build up in the powder tank.
To Next Page
Loading...
Need help?
General
