296
Classifier (Optional) WAVECOM Decoder W74PC, W-PCI/e, W-CODE, W-CLOUD Manual V9.1.0
Help menu
Pressing the Help menu will allow the user to display basic application information.
Data Base Fields
The individual fields of the data base are described below. Please be aware that certain fields are manda-
tory and must be filled – an error message is displayed if such a field has not been filled.
Enter the required receiver bandwidth for this signal.
Baud Rate [Bd]
or Symbol Rate [Bd]
Enter the channel rate in Bd. For two-condition signals, e.g., FSK, PSK-2 or
CW, the baud rate equals the bit rate including channel coding overhead if
any. For two-condition signals without any overhead, the baud rate equals
the user or source bit rate.
The number of times the code check must be executed to obtain the desired
confidence level.
Enter the WAVECOM decoder mode used by the CCC. Selected from a drop-
down list of available modes.
The name given to the table entry by the user. This field is a free text field.
The modulation method used by the decoder. Set by default or selected from
a drop-down list of modulation methods available for the selected decoder.
A user free text field for the ITU emission designator applicable to this signal.
The minimum number of carriers in a multi-carrier system.
The minimum number of channels in a VFT system.
The minimum number of tones in a multi-frequency system.
The number of carriers in a multi-carrier system.
Number of channels in a VFT system.
The number of tones in a multi-frequency system.
If applicable, the frequency of the system pilot frequency, pilot tone or Dop-
pler correction tone.
If checked the signal is not included in the CCC recognition process and the
record is greyed out in the list of records.
The frequency shift for two-frequency FSK.
To Next Page
Loading...
Need help?
General
